I made a call for help regarding Pipewire recently. And got some retoots. Thx for that.

Sadly i have to push that issue again.

I run Open Sound Meter which comes as an AppImage.

Issue:
Somehow OSM doesn't connect to Pipewire but to the audio interface directly. So it doesn't show up in the pw patchbay.

There was a suggestion to configure pipewire-alsa. I found zero helpful information on that matter. Just the general documentation that lists a lot but tutors not so much.

Any hint appreciated.

#Pipewire #wireplumber #AppImage #opensoundmeter #linux #linuxaudio #linuxaudioproduction

I made a call for help regarding Pipewire recently. And got some retoots. Thx for that.

Sadly i have to push that issue again.

I run Open Sound Meter which comes as an AppImage.

Issue:
Somehow OSM doesn't connect to Pipewire but to the audio interface directly. So it doesn't show up in the pw patchbay.

There was a suggestion to configure pipewire-alsa. I found zero helpful information on that matter. Just the general documentation that lists a lot but tutors not so much.

Any hint appreciated.

#Pipewire #wireplumber #AppImage #opensoundmeter #linux #linuxaudio #linuxaudioproduction

And lastly I wanted to mention "Cable". A graphical GUI for managing #PipeWire and #WirePlumber. An amazing piece of software. Simple but so important! Having the basic audio settings like sample-rate or offset and restarting the system-d services at hand. Latter has sadly been needed with my old interface, because it did not get detected by WirePlumber after Stand-By. (3/3)

https://github.com/magillos/Cable/