Discussion
Loading...
Discussion
@stefano the ancient, tiny, underpowered and utterly reliable mAP lite. It chews almost no power as a bonus.
And of course you can also run OSPF, BGP and MPLS on it and act the same as the big routers.
On a side note, try the wAP ax. You won’t regret it for a second. Those things absolutely rock. They are so good I’ve been told that anytime I’m touching something that could be replaced with one to just do it.
@aradke Yes, I'm quite curious to try one. I have a wAP ac LTE in production since late 2020 (if I'm not wrong) and it rocks!
@stefano the wAP ax really leaves the wAP ac for dead.
It also has faster 5GHz wifi than the cAP ax while being 2/3 the price. It has less RAM and a 32bit vs a 64bit CPU compared to the cAP ax, but neither of those should make any difference in an AP. And it’s good on a ceiling, wall or outdoors.
It also has faster 5GHz wifi than the cAP ax while being 2/3 the price. It has less RAM and a 32bit vs a 64bit CPU compared to the cAP ax, but neither of those should make any difference in an AP. And it’s good on a ceiling, wall or outdoors.
@aradke now I'm totally curious to try it 🙂
@stefano
I don't own a device from MikroTik yet, but followed reports by tech people who swear by the price / performance / quality ratio of this devices.
My next Wi-Fi router will most definitely be MikroTik. Same with my next managed switch that will have 2.5 Gbit
@PLA_906114 I like those devices. The price is good, they're reliable and do the job. I'm using them for a lot of stuff. I love that the 15 euros mAP lite has the same features of the most expensive devices. They're like some swiss-knives: the limit is only your imagination 😃
@stefano I'd be curious to know more about your test setup. Specifically what nodes you used, what they their destination pings were and the details of each node. Same for of course the access points.
I wouldn't be surprised to find Ubiquiti APs aren't all that impressive though. They really seem to be trying to do a lot more than most people even wish to do. I just want a set of APs that can support band steering and multiple SSIDs and that's about it.
@cereal_cable Those are two old access points that I had around. I upgraded them to the last firmware release, then performed a factory reset. I configured them in the same way (same SSID, same channel) and put them in the same place. I'm pinging the router - which is connected to the access points via the same cable. So the test is: test one access point, unplug, replace it with the other in the same position, plug it.
I've also an AC PRO here - maybe I could try with that, too.
I've also an AC PRO here - maybe I could try with that, too.
@stefano Nifty, I imagine the older the AP the more likely it will be to have poor performance. I'm expecting the bridging to be a simple Linux bridge on these APs without hardware acceleration of any kind. I'd be curious if release firmware would have been more performant than current firmware even. I theorize that its the CPUs that just aren't keeping up with the bridging via software (even though its through the Linux bridges).
@stefano It might be that the MikroTik has less dependencies or virtually less computation to process the frames. I’m not familiar with the hardware, but Ubiquiti gear has a certain level of bloat (if we can say this) compared to bare metal alternatives.
A Unikernel would always run faster than a regular kernel, just because it computes fewer LOCs.
@stefano I'd be very interested to see if the results hold the same if the two swapped physical positions.
bonfire.cafe
A space for Bonfire maintainers and contributors to communicate
Automatic federation enabled