The previous situation, the main house and apartment were powered by one, two-wire, 110-volt, cable with too small a gauge, and they shared between them two circuit breakers. And I do mean "shared". The upper house and the ceiling of the apartment below were all on the same circuit. Turn on our toaster, dim the apartment lights. When the washing machine was cycling back-and-forth, the lights would dim on each cycle.
The current situation (in progress), 220v, proper gauge, all new wires, fully grounded (as you can see in one of the photos).
The process is...very different than if you had a wooden house. Sledgehammers, hammer and chisel, you just carve out where you want the electrical cables to go.
@nazgul Nice! I assume you'll need to pack that hole through the wall with duct seal or whatever.