That actually worked pretty well. Self-made card edge adapter for HP ham shack power supply. Soldering down those slots a little tough but was able to get a good solder joint along about an inch of wire on each side. Fits nice and tight so it won鈥檛 come off. Need a little more clearance for the resistor soldered on the left. Otherwise good. #electronics #HamRadio #AmateurRadio
Plastic adapter housing and prepared 1mm FR4 board that will make contact with the HP power supply card edge adapter.
Adapter fitted to an HP power supply, with wires attached and slots filled over with hot glue to cover exposed terminals.