Post
My tiny plotter works! I finished most of the controller board last night. It’s running GRBL for ESP32 so I can send jobs over WiFi or BT. Still some clean up and tweaks to the case to make maintenance easier.
It follows B. Dring’s project from 2019 but modified for this tiny plotter.: https://www.buildlog.net/blog/2019/09/inktober-2019-project-post-1/
What should I name it?
I think I've finished building my tiny plotter. It consists of modular 3D-printed boxes that snap together in colors borrowed from the JLPGA edition of the PowerBook 170.
In the top is an ALPS DPG-1302 2.25" wide receipt paper plotter. In the middle section is the ESP32 and motor drivers. In the bottom is a 18650 battery pack with USB-C charger. Hanging off the back is a roll paper holder borrowed from the Commodore 1520 plotter.
A space for Bonfire maintainers and contributors to communicate
