Printing something and it's almost immediately apparent what changes I need to look at in the next version.
4
Replies
0
Boosts
I ihave put waaaay too many holes in this part. Also I need to deal with some stringing issues. Not sure if this is moisture or settings.
@abstractcode PETG? Yeah it strings A LOT. Bump the temperature down a notch and ramp up the non-extruding movement speed as far as you can.
@jpm I have tweaked some of the filament settings, I suspect going slightly higher than Prusa's default temperature was a mistake. Also it seems to be settling a little by turning on the dryer to drop moisture a bit. Not where it needs to be though, so will do more tuning. Drop temp, check speeds etc. I also have been meaning to do the pressure advance because I've tweaked that a little but it's still not where I want it to be at corners.
@abstractcode if only you could just push button make object come out
