Do I know any Australian #electronics nerds who could use a small IR reflow oven? Yours for cost of postage.

This is a Qinsi QS-5100, purchased in 2013. Used only a few times, and probably not for ten years. I just fired it up and the heating element, fan, etc. all seem to work as expected - but it could use a thorough test at minimum.

There's a lot written about these ovens from back in the day, particularly by Ian of Dangerous Prototypes.

If, like me, you only assemble boards in ones and twos for prototypes then TBH you probably don't need this (I use hot air and a preheater). If you do frequent small-ish assembly runs and can be bothered dialling the temp curves in (in theory a one-time process) then it may be of interest.